Filter
Top Products
Rev. 1.0, 07/01, page 74 of 372
Reset state
Standby mode
Active mode
Sleep mode
Subsleep mode
Subactive
mode
Program halt state Program execution state Program halt state
SLEEP
instruction
SLEEP
instruction
Interrupt
Direct transition
interrupt
Direct transition
interrupt
Notes: 1. To make a transition to another mode by an interrupt, make sure interrupt handling is after the interrupt
is accepted.
2. Details on the mode transition conditions are given in table 6-2.
SLEEP
instruction
Direct
transition
interrupt
Direct
transition
interrupt
Interrupt
SLEEP
instruction
Interrupt
Interrupt
SLEEP
instruction
Interrupt
SLEEP
instruction
Figure 6-1 Mode Transition Diagram