Filter
Top Products
DCP200 Profile Controller & Recorder - Product Manual
Page 18 Electrical Installation 51-52-25-150, Issue 1 – April 2009
Board Positions
Board Mounting Struts
Option 4 Module
Option A Module
Option 3 Module
Universal Input Board
Power Supply Board
Option B Module
Option 1 Module
(hidden below B)
Option 2 Module
Option C Module
Figure 3. Rear view (uncased) & board positions
Preparing to Install or Remove Options Modules
CAUTION:
Before removing the instrument from it’s housing, ensure that all power has been
removed from the rear terminals. Modules / boards should only be replaced by a
trained technician.
1. Remove the instrument from its housing by gripping the edges of the front panel (there is a
finger grip on each edge) and pull the instrument forwards. This will release the instrument
from the rear connectors in the housing and will give access to the boards.
2. Take note of the orientation of the instrument for subsequent replacement into the
housing. The positions of the boards in the instrument are shown above.