Filter
Top Products
DCP200 Profile Controller & Recorder - Product Manual
51-52-25-150, Issue 1 – April 2009 Configuration & Use Page 45
Main Menu
This menu is used to access the various features and configuration menus available in the
instrument. The available menus are dependent upon the features and options fitted and the
way in which it has been configured
Entry into the Main Menu
Holding down and pressing from Operation Mode and most other screens will
cause the unit to enter the Main Menu. Each time this key press sequence is made,
the instrument moves to the next menu level above. Sub-menu levels will require this
sequence to be pressed more than once in order to reach the Main Menu.
Navigating the Main Menu
Once in the Main Menu, press or to select the required option
Press to enter the chosen menu.
Scrolling “Help Text” is shown at the bottom of the screens to aid navigation.
Unlock Codes
To prevent unauthorised entry, most modes require a pass-code (1 to 9999) to gain entry.
These modes are indicated by the symbol against their names. The default unlock code
for all modes is 10 and the current codes can be viewed and changed from the Lock Code
View in Configuration Mode. For security, users should to change the codes. If the
Configuration Mode lock code is lost, refer to the Lock code View section of this manual.
Table 5. Main Menu Screens
Main Menu
:
Operation Mode
Display of the process and setpoint values, selection/adjustment of
the Setpoints, auto/manual control, alarm/event status, trend view and
where available, data recorder and profile information.
Setup Wizard
Easy, step-by-step parameter setup for simple applications.
Supervisor Mode
If configured from the PC software, a sub-set of up to 50 Configuration
screens can be accessed.
Configuration Menu
Accesses the sub-menus for Input; Control; Outputs; Alarms;
Communications; Recorder; Clock; Display; Lock Codes and Reset
To Defaults menus and functions.
Automatic Tuning
Selection of Pre-Tune, Self-Tune and Auto Pre-Tune.
Profile Setup Menu
Setting of Global Control Parameters for all profiles; plus Profile
creation, editing and deletion.
Profile Control Menu
Selection of profiles. Running, holding or aborting the selected profile.
USB Menu
Uploading/downloading instrument configuration, profile information
and data recordings.
Recorder Menu
Manually starting, stopping and deleting recordings.
Product Information
Instrument information, including features and options installed.
Service Information
Contact information for service/support etc.