Filter
Top Products
5-12SectionK: Connection Information
121
Key Function
F3 (Nd ordr) Switches the display to node address
order. Once the display has changed to
node address order, the display for this
key changes to “Cn order.”
F3 (Cn ordr) Switches the display to connection order.
Once the display has changed to
connection order, the display for this key
changes to “Nd ordr.”
F4 (Pre Pg) Displays the previous screen.
F5 (Nxt Pg) Displays the next screen.
F6 (Execute) Refreshes the connection information
displayed.
When the display is in connection order,
if this key is pressed after changing the
base node, the display will change so
that this node is displayed at thetop.
In other cases, this key can be used to
re-execute a command and refresh the
display. In this case, if information that is
read from the network is not saved, a
confirmation message will be displayed.
Press “Y” and then the Enter Key to start
reading and displaying the information.
To cancel the operation, press “N” and
then the Enter Key.
F7 (Clear) Clears all the connection information at a
specified node. (Refer to Clearing
Connection Information below.)
F8 (Connect) Switches to the Connection Information
Screen. Once the screen has changed,
the display for this key changes to
“Frame.”
F8 (Frame) Switches to the Frame Information
Screen. Once the screen has changed,
the display for this key changes to
“Connect.”
F9 (Help) Displays a help window for comparison
errors and logic errors. Only available
when the display is in connection order.
F9 (Cancel) The display for this key changes to
“Cancel” when the F6 (Execute) Key is
pressed. Use this key to cancel reading
of node information executed by
pressing the F6 (Execute) Key. This key
can also be used to cancel execution
when a confirmation window is displayed
after F6 (Execute) is pressed.
F10 (End) Cancels reading of information from
nodes and clearing of information, and
exits the Network Configuration Screen.