Filter
Top Products
Appendix BUsing Modems
152
PC Setup
Set up the RS-232C port on the PC using RS-232C Port Setup in the PC Setup from a Programming Device for the
PC. Set the RS-232C port as follows:
Example: Setting the baud rate to 9,600 bps
Set a unit number between 0 and 31. Other items must be set exactly as shown above.
CVM1 and CV-series PC Setup for Built-in Host Link Port
This section describes how to set the communications path selector switch and the DIP switch for CVM1 and CV-
series PCs and set up the Host Link port (RS-232C port) in the PC Setup.
Always turn the PC OFF before setting the communications path selector switch and the DIP switch.
Communications Path Selector Switch
Set the communications path selector switch on the front panel of the PC to RS-232C.
DIP Switch
Open the cover of the Memory Card storage section on the front panel of the PC and set the DIP switch as follows:
Pin No. Setting Setting details
1 – Baud rate of peripheral bus connector
2 –
Pin 50 Kbps 19.2 Kbps 9600 bps 4800 bps
1 OFF ON OFF ON
2 OFF OFF ON ON
3 OFF The value set for Host Link is used.
4 OFF The communications conditions for Host Link connector are
set in the PC Setup.
5 – (Automatic transfer of programs and settings at power-up)
6 OFF No terminator
Set pins 1, 2, and 5 according to your needs. Other pins must be set exactly as shown above.