Filter
Top Products
165
Appendix D
Running the Controller Link Support
Software under Windows 95
The Controller Link Support Software can be set up and run under Windows 95 only when it is to be used for the
Controller Link Unit (for connecting to a PC).
This section describes how to set up and start the Controller Link Support Software under Windows 95. It also
presents some notes on running the Controller Link Support Software under Windows 95.
Note 1. The Controller Link Support Software for the Controller Link Support Board (for running on a computer
node of the network) cannot be run under Windows 95.
2. The Controller Link Support Software cannot be run under Windows 3.1 or Windows NT.
Setting Up the Controller Link Support Software
Note Before starting the setup procedure, be sure to close all active programs.
In the following descriptions, drive C and drive A are the hard disk drive and the floppy disk drive, respectively. If
this system configuration is different from that of you computer, treat drive C and drive A as the hard disk drive and
floppy disk drive in your computer.
1. Start Windows 95.
2. Insert the Controller Link Support Software floppy disk into drive A.
3. Click on the start button on the lower left of the screen.
4. Select Run from the Start menu.
5. Enter A:\SETUP and then click on the OK button. The Controller Link Support Software setup procedure will
start. Follow the instructions displayed on the screen.
6. When the setup procedure is completed, a message will appear on screen indicating that the setup has been
completed.
7. Click on the OK button.
This completes the setup procedure.
Starting the Controller Link Support Software
Note Always run the Controller Link Support Software in full-screen mode. It cannot be run in window mode. Also,
avoid switching to another programs while the Controller Link Support Software is running.
Starting the Controller Link Support Software from Windows 95
1. Click on the start button. The start menu will appear. Then, move the mouse cursor to Program.
2. When the mouse cursor is positioned on Program, the next menu will immediately appear. Then, move the
mouse cursor to SYSMAC.
3. The Controller Link Support Software menu item will appear. Then, click on the menu item.
The Controller Link Support Software will be started.
Starting the Controller Link Support Software in DOS Mode
1. Invoke DOS mode from Windows 95 as follows:
Click on the Start button, select Exit Windows, select Reboot in DOS Mode, then click on the Yes button.
The system will enter DOS mode.
2. While in DOS mode, switch to the directory in which the Controller Link Support Software was installed, then
enter CLKSS and press the Enter Key. The Controller Link Support Software will be started.
Example: Controller Link Support Software in directory CLK in drive C
C:\>CD \CLK
C:\CLK>CLKSS