Filter
Top Products
Additional information
16
152
En
Troubleshooting
Incorrect operation is often mistaken for trouble and malfunction. If you think there is something wrong with this
component, please check the points below. Sometimes the trouble may lie in another component. Investigate the
other components and electrical appliances being used. If the trouble cannot be rectified even after checking the
points below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.
General
Problem
Remedy
The disc is automatically
ejected after closing the
disc tray
• Check that the disc is not an incompatible format disc (page 44).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• Take out the disc and clean it (page 160).
• Check that the disc has a region code compatible with the recorder.
Can’t eject a disc
• Turn off the power to this device and press and hold
OPEN/CLOSE
on the front of the
recorder for more than three seconds.
Can’t play a disc
• Check that the disc is a compatible format disc (page 44).
• Take out the disc and clean it (page 160).
• Check that the disc is loaded properly (aligned in disc tray and label-side up).
• Press
HDD/DVD
to select the DVD.
• There may be condensation in the recorder. Leave the recorder for an hour or so for the
condensation to evaporate.
• During HDD recording, you can’t play discs that are recorded with a Line System different
to the current recorder setting.
• DVD+R/+RW discs recorded using another recorder with copy-once protected recordings
will not play in this recorder.
Can’t record a disc
• Check that the disc is not an incompatible format disc (page 44).
• Some DVD-RAM discs are not recordable until they have been initialized (page 89). This
can take up to an hour.
Remote control does not
work
• If you connected this recorder to the receiver subwoofer using the
CONTROL
IN
jack, point
the remote control at the display unit of the receiver subwoofer to use (page 48).
• Set the remote control to the same ID number as the recorder (page 145). (When the
batteries run down, the remote mode is automatically reset to
Recorder1
.)
• Use the remote within its operating range (page 20).
• Replace the batteries (page 21).
No picture
• Check that everything is connected properly (page 48).
• Check that the connected TV and/or the AV amp/receiver is set to the correct input.
• The recorder may be set to progressive scan with an incompatible TV. Reset to interlace by
pressing and holding the front panel
(Stop) button then pressing
OPEN/CLOSE
.
• If you are using an indoor antenna that requires power, make sure that
Aerial Power
in the
Initial Setup menu is set to
On
or
Auto
(page 138).
• If the aerial/antenna is not connected properly, or if it is shorted, the
Aerial Power
setting
will revert to
Off
automatically. Check the aerial connection and try making the setting again.
• When the HDMI signal is output, no video is output from the
COMPONENT VIDEO OUT
.
All settings are reset
• If the recorder is unplugged (or there is a power failure) while the recorder is on, all the
settings will be lost.
• Make sure that you switch the recorder into standby before unplugging the power cord.
DVRLX60D_WV_EN.book 152ページ ２００７年４月２４日 火曜日 午後７時５８分