Connections
02
52
En
See the manual that came with your cable/satellite
receiver if you’re not sure where the IR receiver is on the
front panel. Alternatively, experiment with the remote
control, operating it from very close range until you find
the place where the receiver responds.
Tip
• This recorder has a ‘through’ function which allows
you to record a TV programme from the built-in TV
tuner in this recorder while watching a video playing
on your VCR (To use this feature when the recorder is
in standby,
Power Save
must be set to
Off
— see
Power Save
on page 137).
Connecting an external decoder box (1)
If you have an external, dedicated decoder box for your
satellite or cable TV system, use the setup described on
this page. See above for how to connect the G-LINK™
cable.
Important
• Do not connect your decoder box directly to this
recorder.
• Information from the decoder (for example, relating
to pay TV services), is only viewable when this
recorder is off (in standby).
• For timer recording to work properly on this recorder,
the VCR/satellite receiver/cable box must also be
switched on during recording.
• It is not possible to watch one TV programme and
record another using this setup.
1 Connect the cable from the antenna/cable TV
outlet to the antenna input on your VCR/satellite
receiver/cable box.
2 Use a SCART cable (not supplied) to connect your
decoder to your VCR/satellite receiver/cable box.
See the manual for your decoder box for more detailed
instructions.
3 Use a SCART cable to connect your VCR/satellite
receiver/cable box to the AV2 (INPUT 1/DECODER)
AV connector on this recorder.
4 Use a SCART cable to connect the AV1 (RGB)-TV
AV connector to your TV.
Connecting an external decoder box (2)
If you only have a decoder, connect it to this recorder and
your TV as shown on this page.
1
Using the setup on this page you can:
• Record scrambled channels received using the
recorder’s built-in analog TV tuner.
Note
1 In order to use this setup, you will need to make the following settings from the Initial Setup menu:
• Set the
AV2/L1 In
setting to
Decoder
from the Initial Setup menu (see
AV2/L1 In
on page 140).
• From the
Manual CH Setting
screen, set the
Decoder
setting for the scrambled channels to
On
(see
Manual CH Setting
on page 139).
AC IN
DIGITAL
AUDIO OUT
COAXIAL
HDMI OUT
CONTROL
G-LINK
IN
AV 1 (RGB) – TV
AV 2 (INPUT 1/DECODER)
S-VIDEO
VIDEOAUDI O
L
R
INPUT 3
COMPONENT VIDEO OUT
Y
P
B
P
R
ANTENNA
IN
OUT
ANTENNA(DIGITAL)
IN
OUT
5 V
30 mA
OUTPUT
TV
Antenna/cable TV
wall outlet
VCR/Satellite receiver
/Cable box
Decoder
1
2
3
4
From SCART AV
connector
To SCART AV
connector
SCART AV
connection
AV2 (INPUT 1/
DECODER)
AV1 (RGB) - TV
To antenna input
DVRLX60D_WV_EN.book 52 ページ 2007年4月24日 火曜日 午後7時58分