Filter
Top Products
Additional information
16
153
En
No sound or sound is
distorted
• Make sure that the amp/receiver or TV is set to the correct input and the volume turned up.
• There is no sound when the picture is paused, or during scanning or slow motion play.
Press
PLAY
to resume regular playback.
• DTS audio can only be played back if the recorder’s digital output is connected to the
receiver subwoofer. If connected to your TV, your TV must have a DTS decoder for you to be
able to enjoy DTS sound.
• Some 96 kHz discs do not output audio through the digital jack.
• Check the audio cable connections (page 48).
• If the sound is distorted, try cleaning the cable plugs.
Cannot switch a bilingual
programme
• During real-time copying it is not possible to switch audio channels. The main and sub
channels are both output.
The picture from the
external input is distorted
• If the video signal from the external component is copy-protected, you cannot connect via
this recorder. Connect the component directly to your TV.
The picture is distorted
• Change the Input Line System setting (page 146). (You can also change it by pressing the
(Stop) button and
INPUT SELECT
on the front panel simultaneously with the recorder
stopped.)
Screen is stretched
vertically or horizontally
• Make sure that the
TV Screen Size
setting (page 143) is correct for the kind of TV you have
(see also page 159).
• If you have a widescreen TV, check its aspect ratio settings.
• This recorder’s input switches into wide mode automatically according to the input signal.
When the unit connected is not compatible with VIDEO ID-1 (widescreen signalling), set the
connected component to output 4:3 aspect ratio (standard) video.
Audio/subtitle language
cannot be changed
•
Note that audio and subtitle languages cannot be changed during the recording of a
digital broadcast.
• You can only use the audio track and subtitles for the language that were selected at the
time of recording a digital broadcast. The audio track and subtitles cannot be changed to
other languages.
Can’t play a disc recorded
using this recorder on
another player
• If the disc was recorded in DVD-R/-RW (Video mode) or DVD+R, make sure that it’s
finalized (page 88).
• Some players will not play recordable DVD discs, even when recorded in DVD-R/-RW (Video
mode) or DVD+R and finalized.
• If the disc was recorded in VR mode, the other player must be specifically RW compatible
in order to play it (page 43).
• Discs recorded with copy-once material cannot be played on non-CPRM compatible
players (page 80).
• DVD+RW discs containing only a small amount of recorded material may not play on other
players. Finalize the disc and try again.
During playback the
picture is dark or distorted
• When a copy-protected disc is played via a VCR, the picture will not display correctly.
Connect the recorder directly to your TV.
Recorded contents are not
clear or artefacts appear in
areas of flat colour (due to
MPEG compression; also
known as
block noise
)
• Change the recording mode to
XP
/
SP
.
Problem
Remedy
DVRLX60D_WV_EN.book 153ページ ２００７年４月２４日 火曜日 午後７時５８分