Filter
Top Products
Additional information
10
38
En
Tuner
Error Messages
Can’t operate using the remote
control.
• Replace the batteries (
Putting the batteries in the remote control
on page 21).
• Operate within 7 m, 30° of the remote sensor (
Using the remote control
on page 20).
• Remove any obstacles or operate from another position.
• Avoid exposing the remote sensor on the front panel to direct light.
• For operating the HDD/DVD recorder, make sure that the control cable and coaxial cable
are connected (page 10).
• If the receiver subwoofer is connected to a Pioneer plasma display with an SR+ cable,
check that the plasma display is switched on. Point the remote control at the plasma
display in order to operate the receiver subwoofer.
• Check that nothing is mistakenly plugged into the
CONTROL IN
jack.
Problem
Remedy
Problem Remedy
Considerable noise in radio
broadcasts.
• Connect the AM antenna (refer to
Connecting up
on page 10) and adjust the direction
and position for best reception. You may also connect an additional internal or external AM
antenna (refer to
Connecting external antennas
on page 34).
• Fully extend the FM wire antenna, position for best reception, and secure to a wall. You
may also connect an outdoor FM antenna (see
Connecting external antennas
on page 34).
• Turn off other equipment that may be causing the noise or move it further away.
Auto tuning does not pick up
some stations.
• The radio signal is weak. Auto tuning will only detect radio stations with a good signal.
For more sensitive tuning, connect an outdoor antenna.
Message
Description
2CH ONLY
• An operation is prohibited because it is only applicable to 2 channel sources, while the
current source is a multichannel source.
96K
• An operation is prohibited because the source is 96 kHz digital.
EXIT
• Appears when a menu is automatically exited after a set period of inactivity.
NOISY
• Background noise is too high to complete MCACC setup successfully.
ERR MIC
• An error occurred during MCACC setup because the microphone is not connected or is
not connected properly.
ERR SP
• An error occurred during MCACC setup because the speakers are not connected or are
not connected properly.
EEP ERROR
• Contact your Pioneer authorized service center or your dealer for servicing.
NO SPTYP
• Try switching the unit off then on again. If the error still appears, please contact a
Pioneer authorized service center or your dealer.
RCS-LX60D_WV.book 38 ページ ２００７年４月２４日 火曜日 午後７時５７分