Filter
Top Products
12 ST-133 Controller Manual Version 3.B
• USB 2.0 interface (Supported by versions 2.5.14 and higher of WinView/32
and WinSpec/32. PTG and USB 2.0 compatibility supported by versions
2.5.15 and higher.)
USB 2.0 Card: USB 2.0 interface card installed in the host computer.
USB 2.0 Interface Control Module: Interface module installed in the
ST-133.
Cable: USB cable. Standard length is 16.4 feet (5 meters) (6050-0494). Other
lengths may be available. Contact Customer Service for more information
• PTG to PI-MAX cable: (6050-0369 or 6050-0406) if PTG is installed. This cable
interconnects the Timing Gen connector on the PTG module with the Timing Gen
connector on the PI-MAX.
• Computer: Can be purchased from Roper Scientific or provided by user.
• Other Components:
• Intensified cameras would additionally require a high-voltage power supply
and/or gate pulser.
Note: The PI-MAX camera is an exception because its high-voltage pulsing
circuits are internal. It would, however, still require a PTG or DG535 Timing
Generator.
Grounding and Safety
The apparatus described in this manual is of Class I category as defined in IEC
Publication 348 (Safety Requirements for Electronic Measuring Apparatus). It is
designed for indoor operation only. Before turning on the controller, the ground prong of
the power cord plug must be properly connected to the ground connector of the wall
outlet. The wall outlet must have a third prong, or must be properly connected to an
adapter that complies with these safety requirements.
If the equipment is damaged, the protective grounding could be disconnected. Do not use
damaged equipment until its safety has been verified by authorized personnel.
Disconnecting the protective earth terminal, inside or outside the apparatus, or any
tampering with its operation is also prohibited.
Inspect the supplied power cord. If it is not compatible with the power socket, replace the
cord with one that has suitable connectors on both ends.
Replacement power cords or power plugs must have the same polarity as that of the
original ones to avoid hazard due to electrical shock.
Environmental Requirements
• Storage temperature -20°C to 55°C
• Operating environment 0°C to 30°C
• Operating temperature range over which specifications can be met is 18° C to 23° C
WARNING
WARNING