Filter
Top Products
128
Fixing the Pitch of Vocals (Pitch Correction)
Rev0.10
In the procedures described thus far, what has been
explained is how to correct the overall pitch for the entire
song, from start to finish, in semitone increments.
In actual practice, however, there may be situations where
you want to correct only a certain section or adjust the pitch
differently. In such instances, use the following procedure.
1
Start by switching to BOUNCE mode and selecting
the patch to which pitch correction is to be applied.
2
Use [CURSOR] to move the cursor to “P.MAP” in the Pitch
Correction patch selection screen and press [ENTER].
The Correction Event Map screen appears in the display.
fig.03-680
In the Correction Event Map screen, you can input the
time at which you want the pitch correction to start as
well as the pitch.
Taken together, this timing and pitch data is referred to
as a “correction event.”
fig.03-690
You can make corrections freely at the desired points
in the song by arranging correction events in the
sequence they occur.
The sequence of correction events with the information
they contain is called a “correction event map”.
Initially, only one correction event, “AUTO” is input at
the beginning of the correction event map.
AUTO :
After the specified point in the song, all pitches are
corrected in semitone increments.
3
Use [CURSOR] to move the cursor to “INSERT” and
press [ENTER].
A new correction event is inserted.
fig.03-700
4
Use [CURSOR] to move the cursor to “Time” and
specify the time at which you want the correction to
start with the TIME/VALUE dial.
fig.03-710
5
Use [CURSOR] to move the cursor to “NOTE” and
specify the pitch you want to correct with the TIME/
VALUE dial.
NOTE :
OFF
No correction is made after the specified point in the
song. The song is played using the original pitch.
AUTO
After the specified point in the song, all pitches are
corrected in semitone increments.
C, C#, –A#, B
The performance after the specified point in the song is
adjusted to the specified pitch.
Making Detailed Settings
for Pitch Correction
(Correction Event Map)
Time
Pitch
Correction
start point
Next event
start point
Vocal pitch
Correction
pitch
Time
Smth
(Correction Speed)
NOTE
You cannot change the time of the correction event at
the start of the song.
The reference pitch for NOTE is determined by the
tuner’s reference pitch. See “Setting the Reference Pitch
of the Tuner” (p. 193).
BR600_e2 128ページ ２００６年４月１７日 月曜日 午前９時３分