Filter
Top Products
20
Panel Descriptions
Rev0.10
Track/Fader section
TRACK MIXER fader 1–4, 5/6–7/8
For controlling the volumes of each track during playback.
RHYTHM fader
Adjusts the volume of the Rhythm.
“Playing Arrangements” (p. 41)
“Playing Patterns” (p. 41)
MASTER fader
Controls the overall volume of the BR-600.
“Listening to a Demo Song” (p. 32)
REC TRACK (Recording Track) buttons 1–4, 5/6–7/8
Use these buttons to select to which track you will record.
The button of the track selected will flash in red and then
light in red when recording begins. When recording is
finished, the button of the selected track will light
alternately in orange and green.
The relationship between the indicator and the track
conditions is given below.
Off :
This track contains no recorded data.
Green :
An audio track that contains recorded data.
Flashing in red :
The track is selected as the recording destination, and is in
recording standby.
Red :
This track currently being recorded.
Lighting alternately in orange and green :
This track contains recorded data and is selected for
recording.
“Recording” (p. 54)
[TAP (TEMPO)]
By tapping this button, you can set the tempo for the
Rhythm.
“Tapping to change the tempo of the
arrangements or patterns” (p. 43)
[DELETE/MUTE]
You can mute the sound on a track by holding down this
button and pressing the REC TRACK button for that track.
Performing this same operation again cancels the mute.
While the sound is muted, the REC TRACK button for the
track flashes orange or green.
* If a recording track was muted, muting will be defeated
when recording ends.
“Silencing the sound of specific tracks (Track
Mute)” (p. 47)
During creation of Rhythm patterns, you can delete rhythm
sounds you have input by holding down this button and
pressing the Drum Pads.
“Deleting Unneeded Drum Sounds” (p. 147)
6
BR600_e2 20 ページ ２００６年４月１７日 月曜日 午前９時３分