Filter
Top Products
95
Using the Insert Effects
Rev0.10
Section 3
By default, the insert effect is inserted immediately after the
input source. The reason for this is to allow for the effects-
processed (wet) sound to be recorded and monitored.
However, sometimes you want to change the connection
order.
On the BR-600, you can accommodate a wide variety of
situations by changing the point to which the insert effects
are connected.
Follow the procedure below to change where insert effects
are connected.
1
Confirm that [PAD] is not lit, then press [EFFECTS].
2
Press CURSOR [ ] [ ] to move the cursor to
“LOCAT,” and press [ENTER].
fig.03-100
3
Turn the TIME/VALUE dial to switch the point to
which the insert effects are connected.
The sound is monitored and recorded after it passes
through the insert effect. Normally you will use the BR-600
with this setting.
fig.03-110
The sound is monitored through the insert effect but is
recorded without the effect (dry). Use this when you wish
to try out various effects after recording.
fig.03-120
The insert effect can be applied to the playback of a track (or
pair of tracks). Use this when you wish to try out effects
after recording the dry sound, or when you wish to apply
effects only to a specific track.
fig.03-130
The insert effect can be applied to the playback of a Rhythm.
fig.03-140
Use this when you wish to apply effects to the entire song,
such as when adjusting the tone or applying a special effect
during mixdown.
fig.03-150
4
Press [EXIT] to return to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
Changing the destination
Insert Effects are Connected
■
INPUT<NORMAL> :
TRACK 1
(REC)
■
INPUT<REC DRY> :
■
TRACK
1–8,
1
2,
3
4,
5
6,
7
8
:
■
RHYTHM :
■
MASTER :
TRACK 1
(REC)
TRACK 1
(PLAY)
RHYTHM
TRACK 1
(PLAY)
TRACK 8
(PLAY)
RHYTHM
BR600_e2 95 ページ ２００６年４月１７日 月曜日 午前９時３分