Filter
Top Products
44
Rev0.10
Recording
1
Press either [1]–[7/8] at REC TRACK to select the
recording track.
If the button flashes in red, that track is ready for
recording.
fig.00-480
The status of each track can be determined from the
indicator on the button.
Off :
No recorded data exists on the track.
Green :
Recorded data exists on the track.
Red :
The track is selected for recording.
If a track with existing data is selected for recording,
the indicator will light alternately in orange and green.
If INPUT SELECT [GUITAR] is lit
fig.00-490
Since the input is mono, the recording is normally
performed as a mono recording onto one track. Press one of
TRACK [1]–[4] at REC TRACK to select the one track to
which to record.
However, if you want to record in stereo to increase the
effect of insert effects, you can simultaneously press the [1]
and [2], [3] and [4] REC TRACK buttons for stereo
recording onto two tracks.
fig.00-500
In addition, Tracks 5/6 and 7/8 are stereo tracks, so they
always produce stereo recordings.
If INPUT SELECT [MIC] is lit
fig.00-490
If a mic is connected either to the MIC1 or MIC2 jack (not
both), the input will be mono, and you can select tracks
using the same procedure as that described in “If INPUT
SELECT [GUITAR] is Lit.”
If you have mics connected to both the MIC1 and MIC2
jacks, or if nothing is connected to either of these jacks and
the internal stereo mic is switched on, you can select tracks
using the same procedure as that described in “If INPUT
SELECT [LINE] or [SIMUL] are Lit.”
* When mics are connected to both the MIC1 and MIC2 jacks,
Track 1 is selected as the recording destination for MIC1,
and Track 2 is selected as the recording destination for
MIC2.
If INPUT SELECT [LINE] or [SIMUL] are lit
fig.00-510
Since the input is stereo, the recording is normally
performed on two tracks. Press either REC TRACK [1] or [2]
to select tracks 1 and 2, or [3] or [4] to select tracks 3 and 4.
However, if you want to mix together the left and right
channels being input onto one track, with tracks 1 and 2
selected, press REC TRACK [1] again to select track 1. Using
the same procedure, you can select any track 1 to 4 to be the
track to which to record.
In addition, Tracks 5/6 and 7/8 are stereo tracks, so they
always produce stereo recordings.
■
Selecting the recording track
(Recording Mono)
(Recording Stereo)
or
BR600_e2 44 ページ ２００６年４月１７日 月曜日 午前９時３分