Filter
Top Products
Rev0.10
35
Quick Start
Preparing Songs For Recording
When the memory card contains more than one song, the
song that was recorded last is automatically selected.
To record a new song, follow the procedure given below.
fig.00-250
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“NEW,” and press [ENTER].
“Type” appears in the display.
fig.00-260
3
Turn the TIME/VALUE dial to select the desired data type.
Ordinarily, you should select the data type that meets
your needs for a particular recording situation, while
considering the desired quality and recording time.
However, for our purposes here, you can select HiFi (MT2).
For more about data types, refer to“Recording”
(p. 54).
4
Press [ENTER].
“Are you sure?” appears in the display.
fig.00-270
5
Press [ENTER].
When the new song is ready, you are returned to the
Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
■
Recording a new song
(Song New)
1
2,4,5
3
2
The BR-600 uses a sample rate of 44.1 kHz. It is not
possible to change the sample rate.
BR600_e2 35 ページ ２００６年４月１７日 月曜日 午前９時３分