Filter
Top Products
80
Editing the Performance on a Track (Track Edit)
Rev0.10
10
Press [ENTER].
fig.02-410
11
Use [CURSOR] and the TIME/VALUE dial to specify
the time of the beginning of the location “T” (To)
where you want the data moved.
12
When you are ready to execute the move, press
[ENTER].
The display will ask “Are you sure?,” so that you can
confirm the operation.
13
Press [ENTER].
Move Event is executed.
14
Press [UTILITY] (or press [EXIT] repeatedly) to
return to the Play screen.
* During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
Perform the procedure given below to move the portion
from the repeat start (A) to the repeat end (B).
Ex. 1 : Moving to the same track
fig.02-280
Ex. 2 : Moving to another track
fig.02-290
1
Confirm that [PAD] is not lit, then press [UTILITY].
2
Press CURSOR [ ] [ ] to move the cursor to
“TRK,” and press [ENTER].
fig.02-300
3
Press CURSOR [ ] [ ] to move the cursor to
“MOV,” and press [ENTER].
fig.02-310
After specifying the time in the procedure above, a “+”
may appear to show that there is a discrepancy between
the actual current position and the position displayed. If
you specify the locations using measures, specify the
locations at each screen using the TIME/VALUE dial to
eliminate the discrepancy.
You can also enter the time using [LOCATOR], [ZERO],
[STOP] + [REW], [STOP] + [FF], and AUTO PUNCH
[IN/OUT].
■
Moving the repeated
portion (AB)
Repeat
Start (A)
Repeat
End (B)
TO Time
Repeat
Start (A)
Repeat
Start (B)
TO Time
BR600_e2 80 ページ ２００６年４月１７日 月曜日 午前９時３分