Filter
Top Products
58
Chapter 6 Using the Built-in Effects
LOW SLOW
(Low frequency slow rate) 0.05–10.0 Hz
Specify the low-speed (SLOW) rotational speed of the low-
range rotor.
HIGH FAST
(High frequency fast rate) 0.05–10.0 Hz
Specify the high-speed (FAST) rotational speed of the high-
range rotor.
LOW FAST
(Low frequency fast rate) 0.05–10.0 Hz
Specify the high-speed (FAST) rotational speed of the low-
range rotor.
SPEED Slow/Fast #
Select the rotational speed of the low-range rotor and high-
range rotor.
Slow:
The specified rotational speeds (the LOW SLOW RATE/
HI SLOW RATE values) will take effect.
Fast:
The specified rotational speeds (the LOW FAST RATE/
HI FAST RATE values) will take effect.
HIGH ACCL (High frequency acceleration) 0–15
Specify the time required for the rotational speed of the high-
range rotor to change from the low speed to the high speed
(or from the high speed to the low speed). More time will be
required as the value of this parameter is decreased.
LOW ACCL (Low frequency acceleration) 0–15
Specify the time required for the rotational speed of the low-
range rotor to change from the low speed to the high speed
(or from the high speed to the low speed). More time will be
required as the value of this parameter is decreased.
HIGH LEVEL (High frequency level) 0–127
Specify the volume of the high-range rotor.
LOW LEVEL (Low frequency level) 0–127
Specify the volume of the low-range rotor.
SEPARATION 0–127
Specify the spaciousness of the sound.
LEVEL (Output level) 0–127
Specify the output volume.
9: COMPRESSOR
Compressor is an effect which restricts high sound levels and
boosts low sound levels, thus smoothing out variations in volume.
fig.6-13
SUSTAIN 0–127
Specify the time over which low-level sounds are boosted to
a constant volume level.
ATTACK 0–127
Specify the attack time of the input sound.
PAN (Output pan) L64–0–R63
Specify the stereo location of the output sound.
A setting of L64 is far left, 0 is center, and R63 is far right.
POST GAIN 0/+6/+12/+18 dB
Specify the output level.
LOW GAIN -15–+15 dB
Specify the low frequency range gain (amount of boost or cut).
Positive (+) settings will emphasize (boost) the low
frequency range.
HIGH GAIN -15–+15 dB
Specify the high frequency range gain (amount of boost or
cut).
Positive (+) settings will emphasize (boost) the high
frequency range.
LEVEL (Output level) 0–127 #
Specify the output volume.
10: LIMITER
Limiter is an effect which compresses sounds that are louder than
a specified volume level, preventing distortion from occurring.
fig.6-14
THRESHOLD (Threshold level) 0–127
Specify the volume level at which compression will begin.
RELEASE (Release time) 0–127
Specify the time from when the volume falls below the
threshold level until the limiter effect no longer applies.
RATIO (Compression ratio) 1.5:1/2:1/4:1/100:1
Specify the compression ratio.
L in
R in
L out
R out
Pan R
Pan L
Compressor
2-Band
EQ
L in
R in
L out
R out
Pan R
Pan L
Limiter
2-Band
EQ