Filter
Top Products
4- & 8-Channel Digital Video Recorder
19
The Temperature column displays the temperature of the storage device.
Good – The temperature does not exceed the user-defined temperature threshold.
Bad – The temperature exceeds the user-defined temperature threshold.
N/A – The DVR cannot read the temperature.
The S.M.A.R.T. column displays “Good”, “Bad” or “N/A”, depending on storage conditions.
Good – The storage condition is normal.
Bad – Data cannot be written on or read from the storage device.
N/A – Storage conditions are normal, however, the S.M.A.R.T. monitoring is not working or supported.
NOTE: When the S.M.A.R.T. displays Bad, the screen displays a message box. Once the
“Bad” message displays, replacing the hard disk drive is recommended, usually within 24
hours.
NOTE: Temperature and S.M.A.R.T. information will be available only for internal hard
disk drives supporting the SMART (Self-Monitoring Analysis and Reporting Technology)
monitoring program.
User
Highlight User in the System menu and press the button. The User setup screen displays the
authorized groups and users. You can add and delete groups and users. When adding a group,
you can assign authority levels to the group.
Figure 14 ─ Storage Status setup screen.
The Type column displays the type of storage
device.
The Disk Bad column displays the percentage
of bad sectors.
Not formatted – The device is not formatted.
Good – Less than user-defined percentage of bad
disk sections is damaged.
Bad – More than user-defined percentage of bad
disk sections is damaged.
Figure 15 ─ User setup screen.
The +/- column is used to collapse and expand
user groups. If there is a + or – in this column,
it indicates the item is a Group Name. If there
is a – in front of the Group Name, it indicates
that the group has been “expanded” and all of
the User Names within that group are displayed
below the Group Name. If there is a + in front
of the Group Name, it indicates that the group
has been “collapsed” and all of the User Names
within that group are hidden. To collapse or
expand a group, highlight the +/- column in front
of the desired group and press the
button.