Filter
Top Products
4- & 8-Channel Digital Video Recorder
37
Highlight the box under the Alarm-Out heading and press the button. Select between Alarm
Output and Beep (DVR’s internal buzzer) that you would like to activate and to sound whenever
the DVR detects video blind on the selected camera.
NOTE: For the Alarm-Out action, the alarm output and beep you select should be set to
the Event mode in the Alarm-Out setup screen (Schedule tab).
Highlight the box under the Notify heading and press the button. You can toggle the entire list
On and Off by highlighting Notification and pressing the
button. You can toggle the individual
items On and Off by highlighting that item and pressing the
button. Highlight OK and press
the
button to accept your changes.
NOTE: For the Notify action, the notify item you select should be enabled in the Notification
setup screen and the DVR should be registered in the Speco Central (Remote Administration
System).
Highlight the desired box under the PTZ heading, and press the button. A list of PTZ presets
appear. Select the preset position for each PTZ camera, where you want PTZ cameras to move
to when the DVR detects video blind on the selected camera’s input.
Text-In
Highlight Text-In in the Event menu and press the button. The Text-In setup screen appears.
Figure 37 ─ Text-In Settings setup screen.
The DVR can be set to react to text input from
devices such as ATMs (Automated Teller
Machines) and POS (Point of Sale; i.e., cash
registers). This screen allows you to configure
the DVR for each text-in device.
Highlight the box under the Setup heading, and
press the
button. Selecting the Setup
heading changes all the parameters excluding
Port settings of all the text input channels.
NOTE: The system performance might be
affected when a large quantity of text inputs
are detected from several channels at the
same time.
Figure 38 ─ Text-In Device setup screen.
Highlight the box beside Port, and press the
button. Select from None, RS232, RS485, USB-
Serial (1~8) and LAN (1~8).
NOTE: If you have set the Port as None, you
will not be able to make any changes to the
screen.
NOTE: When using the USB to serial text-in
device, do NOT remove the USB cable from
the port while the system is running.