Filter
Top Products
Startup
309301G 23
Startup
Follow this procedure to start the ProDispense system for the first time (initial startup) or after
the system has been shut down.
1. Turn on the power. The ProDispense system startup screen will display while the system
is starting, then the Run screen (page 30) or System Setup screen (page 26) will appear,
depending on the mode of operation the system is in. For an explanation of operation
modes, see page 11.
2. If this is the initial startup, change to Setup Mode (page 25) and complete the setup pro-
cedures.
3. Change to the Dispense Mode Run screen if you are not there already (page 29).
4. Make sure the dispense lines run into the proper reservoir.
5. Load the fluids (page 34).
FloSync
Software revision
ProDispense: Rev. X.XX
Startup screen