Filter
Top Products
WARNING
6 309301G
WARNING
FIRE, EXPLOSION, AND ELECTRIC SHOCK HAZARD
Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result
in fire, explosion or electric shock.
• Installation and service of electrical components must be completed by a qualified electrician.
• Do not install the ProDispense controller, fluid panels, or remote operator station in a hazardous
location.
• Ground the equipment. See Ground the System, page 20.
• If there is any static sparking while using equipment, stop dispensing immediately. Identify and
correct the problem.
• Provide fresh air ventilation to avoid buildup of flammable fumes.
• Eliminate all ignition sources, such as cigarettes.
• Avoid spilling fluids onto electrical components.
• Turn off the ProDispense controller power switch before servicing equipment.
TOXIC FLUID HAZARD
Hazardous fluid or toxic fumes can cause serious injury or death if splashed in the eyes or on the skin,
inhaled, or swallowed.
• Always wear protective eyewear, gloves, clothing and respirator as recommended by the fluid and
solvent manufacturer.
• Know the specific hazards of the fluid you are using.
• Store hazardous fluid in an approved container. Dispose of hazardous fluid according to all local,
state and national guidelines.
EQUIPMENT MISUSE HAZARD
Equipment misuse can cause the equipment to rupture or malfunction and result in serious injury.
• This equipment is for professional use only.
• Read all instruction manuals, tags, and labels before operating the equipment.
• Use the equipment only for its intended purpose. If you are not sure, call your Graco distributor.
• Do not alter or modify this equipment.
• Check equipment daily. Repair or replace worn or damaged parts immediately.
• Do not exceed the maximum working pressure stated on the equipment or in the Technical Data,
page 71.
• Use fluids and solvents which are compatible with the equipment wetted parts. Refer to the Techni-
cal Data in all equipment manuals and the fluid manufacturer warnings.
• Route hoses away from traffic areas, sharp edges, moving parts, and hot surfaces. Do not expose
Graco hoses to temperatures above 180° F (82° C) or below -40° F (-40° C).
• Comply with all applicable local, state, and national fire, electrical, and safety regulations.