Filter
Top Products
Included Software Setup
________________________________________________________________________________________________________
122
Configuring the Client PC
All configurations take place in the Alarm Monitor Window on the client PC. For
descriptions and locations of the buttons and features of the Alarm Monitor Window,
refer to the Alarm Monitor Window section later in this chapter.
1. Open the Alarm Monitor Window on the Client PC. Start >Programs > Fusion >
Alarm Monitor > Alarm Monitor.
2. Click New in the DVR List and enter the site code, site name, and IP Address of the
DVR in the Site Edit window. Click Save.
Note The site code can be found under the Information tab in the Setup Menu.
3. Click the Tools Menu and select Setup.
4. Confirm that the Listen Port in the Configuration Window is set to the same number
as the Emergency Port in Communication Settings on the DVR. If the numbers are
different adjust the Listen Port on the client PC to match the DVR.
5. Click Enter.
6. Reboot the client PC.