Filter
Top Products
Making Connections
________________________________________________________________________________________________________
32
Connecting a PTZ Camera
Setting up a PTZ Camera is simple. The recorder comes preassembled with an internal
PTZ adapter. The cabling may be run up to 4,000 ft using 22 Gauge Twisted Pair.
It is important to understand how the PTZ connects to the recorder. The recorder
outputs an RS-232 signal and converts in to an RS-422/485 signal which is then sent to
the PTZ camera.
Attaching the 4-Pin Adapter
1. Locate the PTZ adapter cable
2. Connect the wires of the PTZ adapter to the
PTZ camera. The yellow wire should
connect to the RX+ on the camera and the
orange wire should connect to the RX-.
3. Connect the other end of the adapter to the
XVR unit as shown.
4. Assign the PTZ camera an ID number in
PTZ Setup that coincides with the number
assigned to the camera. This is normally
done utilizing a dip-switch configuration
method on the addressable dome.
Example: If the camera is plugged into
input number 5, set the PTZ unit to ID number 5.
Optional Components
To fully utilize the potential of the DVR, several optional Fusion components are listed
below. Contact a dealer for more information.
• Multiplex Video Output Card (MUX) • Internal Raid 5
• 4 Port Analog Output Card • External SATA Storage
• Gigabit 10/100/1000 NIC Adapter • External RAID 5 Storage
• Fusion Remote Video Software • SCSI Interface card
• Fusion Video Management Software • Performance package upgrade
• HVR/NVR Upgrade
RS-422
Signal Line (+)
Signal Line (-)