Filter
Top Products
Fusion IV DVR User Guide
________________________________________________________________________________________________________
Document 800-05305V1 Rev B 31
10/11
Looping Outputs
The 8/16 Channel recorders have up to 16 looping outputs. Depending on the
destination of the looping outputs, each one may have to be terminated.
CH 1 in CH 2 in CH 3 in CH 4 in CH 5 in CH 6 in CH 7 in CH 8 in CH 9 in CH 10 in CH 11 in CH 12 in CH 13 in CH 14 in CH 15 in CH 16 in
CH 1 Out CH 2 Out CH 3 Out CH 4 Out CH 5 Out CH 6 Out CH 7 Out CH 8 Out CH 9 Out CH 10 Out CH 11 Out CH 12 Out CH 13 Out CH 14 Out CH 15 Out C H 16 Out
The 32 Channel recorder has up to 32 looping outputs. Connect the included 16
Channel BNC Connector Cables to the 16 Channel Cable Adapter ports.
The video inputs/outputs are 75 Ώ BNC connectors. Make sure there is a video source
connected to the input and then connect a cable to the Channel Out on the BNC
Connector Cable. The looping outs can be connected to video monitors or combined
with adapters to connect to VCRs.
Looping Output Termination
When it is necessary to terminate a looping output, the recorder has built in termination
that allows users to select individual outputs. It is not always necessary to terminate the
output; it depends on the device to which you are connecting. As a rule, if the image
appears distorted or virtually unviewable, it likely needs to be terminated.
Always leave the dipswitch set to the ON position when the Looping Outputs are not
used.
ON Not connected to a
monitor (Normal)
OFF Connected to a
monitor (Looped)
CONTROL
1 2 3 4
COM
SEN SOR
ON
O FF
ON
O FF
BNC A
BNC B