Filter
Top Products
Fusion IV DVR User Guide
________________________________________________________________________________________________________
Document 800-05305V1 Rev B 33
10/11
Turning On the Recorder
Once the cables and adapters have been properly connected it is time to turn on the
power. To turn on the power follow these steps:
1. Turn on the monitor and any external peripherals (ex. Printers, External Storage
Devices, etc.) connected to the recorder.
2. Turn on the Secondary Power Switch located in the rear of the recorder.
3. Turn on the main power switch located on the front of the recorder.
The recorder will run a series of self-tests. After two or three minutes a series of
messages may be displayed as the various hardware and software subsystems are
activated. Under normal circumstances you should not be asked to respond to these
messages. If you are asked to respond to the messages (adding a Printer, Monitor, etc
for the first time) follow the instructions carefully.
After this finishes, the Fusion recorder software should load automatically and bring you
to the main screen.
Turning Off the Recorder
To turn off the recorder, select the Exit button on the main screen and select Power Off.
The recorder will safely shutdown, it may take several minutes to shut down completely.
Caution Always be sure to follow the proper procedures when turning off the power
to the recorder. NEVER disconnect the power to the recorder while it is still
running or in the process of shutting down. Doing so can cause data loss,
file corruption, system instability and hardware failure