Filter
Top Products
Fusion IV DVR User Guide
________________________________________________________________________________________________________
Document 800-05305V1 Rev B 131
10/11
Health Check
FVMS Health Check is used to monitor the status of Network, Video, Recording, and
HDD storage space on remotely connected Fusion DVRs. Health Check also provides
the user with detailed information on each of the DVRs connected, including the
software version running, whether cameras are recording in Motion or Continuous mode
and other important information. The DVR transmits this information on port 4005
(default). You can also enable E-mail alarms to be sent on a Health Check Event
(Warning or Failure event).
Highlights:
• Can monitor multiple DVRs on the Health Check Main page – up to 100 DVRs.
• Able to define the number of occurrences before a Warning or Failure alarm is
triggered.
• Check interval times allow FVMS to check the Fusion DVRs status once every 10
minutes or up to once every 7days.
• Independently enable or disable Health Check on each connected Fusion DVR.
• Independently select warning and failure notification counts for Video Loss,
Recording failures, Disk Free Space %, and Storage Failures.
• Enable custom Voice Warning on Failure alert.
• Detailed status screen provides the following information:
• DVR Information: including last Health Check time, Total # of channels
recording, DVR software version running, current working drive, and
disconnected time.
• Video and Recording information: including the recording status of each camera
channel and whether or not it is Motion or Continuous, and if there is a Video
Signal from each of the channels
• HDD Storage Status Bar: indicates the amount of Free and Used space
remaining on the HDD.
• Enable an E-mail to be sent on a Warning or Failure Health Check Event –
Enabled through the Admin>Enable Email Alarm setup window.
• Ability to Export Status Summary Information, from each independently selected
DVR, to HTML, TXT, or Excel formats.
• Summary information of Network Status, Disk Status, Video Status, Capture
Status and Storage Status indicating Good, Warning or Failure, along with the
specifics about each. Also includes the overall Total status of the DVR.
Enable Health Check on the Fusion DVR
1. Enter Setup on the DVR.
2. Click the Network tab.
3. Clear the Disable Remote Control check box.
4. Select the Enable Health Check check box.
Note The default connection port is 4005; only change this if necessary.
5. Click Apply.
6. Click OK.