Filter
Top Products
14
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
Attaching and removing the HDD to the DX-NT400E
Make sure that the POWER button on the front panel and the MAIN switch on the rear panel are both turned OFF
when attaching or removing the HDD tray.
Do not remove the top cover of the unit.
HDDs are very sensitive to sudden shocks and vibration which can permanently damage the internal components. To
avoid damage to the HDD:
i) Hold tray firmly with both hands while transporting.
ii) DO NOT use an electric screwdriver.
iii) DO NOT place the HDD directly on a desk or table. use a cushion.
This unit does not operate when the HDD is not attached. Be sure to attach the HDD before using the unit.
When replacing the HDD only for playing back the recorded image, replace the recorded HDD togather with the tray.
When you remove the top cover of the tray and remove only one HDD or replace the MASTER HDD or the SLAVE HDD
with another one, in most cases the recorded image cannot be played back.
When the protection sheet is stuck on the attaching part of the HDD tray on the front of the unit, remove it before
using.
The following HDDs have been tested and compatibility is ensured. This information is as of June 2003. Supply of
these HDDs may be stopped or they may be changed without notice by their respective manufacturers. Consult your
dealer for the latest information or use of other HDDs. When you attach 2 HDDs, normally use the HDDs of the same
capacity and the same model name.
<MAXTOR>
4G120J6 (120 GB)
4R120L0 (120 GB)
4R160L0 (160 GB)
4A250J0 (250 GB)
<SEAGATE>
ST3160022ACE (160 GB)
All the company names appearing herein are the property of their respective owners.
The unit may not operate correctly depending on type or condition of the HDD.
Do not attach or remove the HDD tray unnecessarily. The HDD tray is presumed to be removed and attached only a
few times a month because of the structure of the connectors.