Filter
Top Products
83
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••• Speficications
ENGLISH
Specifications
Rated Power Supply: AC 100 - 240 V 50/60 Hz
Rated Input: 0.4 - 0.2 A (100 - 240 V) (with 2 HDDs described on page 14 attached )
Color System: PAL-type color system
Operating Temperature: 5 °C to 40 °C
Relative Humidity: Max. 80 %
Altitude: Max. 2000 m
Dimensions: 300 (Width) x 343 (Depth) x 88 (Height) mm
Weight: 5.8 kg
Recording System Digital recording method using WAVELET compression
Sampling 13.5 MHz
Data Compression WAVELET
Compression Unit Field
Resolution 684 x 288
Recording Device 3.5 inch IDE HDD x 2 (Maximum capacity: 2 TB)
Use with attached to the HDD tray
Video Input: 4 Input BNC-Connector: 1.0 V (p-p), 75
Video Output: 1 Output BNC-Connector: 1.0 V (p-p), 75
Audio Input: 1 Input RCA-Pin plug: 308 mV (rms), 50 k
Audio Output: 1 Output RCA-Pin plug: 308 mV (rms), 1 k
Timer Program: 8 programs-Daily start and stop time for one week x 3 set
Memory Backup: Lasts for more than 1 month
CONNECTORS
ALARM IN(1-4) Input: Terminal for starting alarm recording
EMERGENCY Input: Terminal for starting emergency recording
GND: Terminal for ground
MODE OUT(1-5) Output: Terminal for indication of the operational state of the unit
RS-232C: RS-232C (D-SUB 9 pin) connector for connection with personal computer
ETHERNET: Connector: RJ-45 connector,Physical interface: 10BASE-T
REMOTE: Connection with the wired remote control R-400
Rating:
MODE OUT(1-5) Active: “Low” Level Max. Drive current 7 mA DC
Non active: Open Max. Voltage +24 V DC
EMERGENCY Active: When terminals are short-circuited or “Low” Level voltage is applied
Non active: Open
Accessories
AC power cord 2 (for U.K/for the Continent)
Wired remote control R-400 1 (Length of the cable: 2 m)
Screw to attach the HDD holder to the HDD 8
Weight and dimensions shown are approximate.
Design and specifications are subject to change without notice.
This unit complies with the European EMC test standard EN50130-4.