Filter
Top Products
22
En
02
Install Your Flat Panel TV
8 ) Insert the cable in the groove on the speaker.
9 ) Connect the other end of the speaker cables to the rear of the panel.
Refer to “
2.2.2 Connect the Speaker Cables.”
Note: If the speaker needs to be repositioned (horizontally or vertically) after it is attached, loosen the speaker
mounting screws first. Adjust the position then retighten the screws.
2.2.2 Connect the Speaker Cables
1 ) Press down on the tab.
2 ) Insert the appropriately colored wire into the opening.
3 ) Allow a small percentage of the cable’s bare wire to remain visible.
4 ) Release the tab to clamp the wire.
If the bare wire is hidden when the tab is released, repeat Steps 1
through 4 until the proper amount of cable is showing.
5 ) Repeat this process for each cable, matching the color of the wire to the
appropriate terminal.
6 ) Connect the speaker cables to the speaker.
7 ) Bundle the speaker cables, power cord and other cables in the cable
clamp then insert the clamp into an appropriate hole on the rear of the
flat panel TV.
Refer to “2.7 Route then Bundle the Power Cord and Cables.”
Use the clamps as necessary (see page 33).
Speaker cable
(PRO-111FD)
(PRO-151FD)
Speaker
terminal
Insertion
in groove
Speaker cable
Speaker terminal
Insertion
in groove
tab
Gray
Speaker cable
Gray
Black
Speaker terminal
Black
Red
Red
(PRO-151FD)
PRO151FD.book Page 22 Wednesday, April 2, 2008 10:19 AM