Filter
Top Products
76
En
04
Additional Picture and Sound Adjustment Options
4.8 Manage the Power
Your flat panel TV is energy efficient but includes functions to save additional power. In an earlier section entitled
“3.6 Smart Starts for New Owners”, you were told how to activate the Energy Save feature. This section provides
more advanced functions to save power and to extend the panel life.
AV/PC Source - Picture Off
To save energy and extend the life of your flat panel TV, have the screen turn Off. To deactivate the screen, follow
the steps below.
1 ) Press TOOLS on the remote control.
The TOOLS Menu appears on screen.
2 ) Select
Picture Off
from the TOOLS Menu.
3 ) Press ENTER.
The screen display turns Off.
To restore the screen display, press any buttons other than
VOL +/–
and
MUTING
.
Note: The Picture Off setting is not memorized by the system.
AV Source - No Signal
To save energy and extend the life of your flat panel TV, the panel can enter Standby automatically if the AV source
signal fails for 15 consecutive minutes. At five minutes before and at every minute after that, a warning message
appears on the screen. When the final minute elapses, the panel switches to Standby.
To have the panel switch to Standby when an AV source signal fails, follow the steps below.
1 ) Access the
Power Control
through the
Setup.
2 ) Select
No Signal off
from the Power Control menu.
3 ) Select
Enable
to activate the AV Signal off power function.
4 ) Press HOME MENU to exit the menu.
Note: The flat panel TV may switch to Standby when there is noise (signal interference) at the end of a broadcast
schedule (channel goes off-air).
AV Source - Non-Operational
To save energy and extend the life of your flat panel TV, the panel can enter Standby automatically if there are no
commands from the AV source for three consecutive hours. At five minutes before and at every minute after that,
a warning message appears on the screen. When the final minute elapses, the panel switches to Standby.
To have the panel enter Standby automatically when there are no commands from the AV source, follow the steps
below.
1 ) Access the
Power Control
through the
Setup.
2 ) Select
No Operation off
from the Power Control menu.
3 ) Select
Enable
from the No Operation off menu.
4 ) Press HOME MENU to exit the menu.
PRO151FD.book Page 76 Wednesday, April 2, 2008 10:19 AM