Filter
Top Products
27
En
02
Install Your Flat Panel TV
Attach the Color Sensor to the Rear Panel
Methods of attaching the color sensor to the rear panel differ depending on the panel with or without side-
mounted speakers.
(when side-mounted speakers are installed)
1 ) Remove the screws of the color sensor then replace the bracket.
Use the removed screws again.
2 ) Loosen the upper two (2) speaker bracket screws.
3 ) Fit the color sensor bracket’s lower grooves into the screws.
Adjust the color sensor/speaker bracket positions so as to stay in place.
4 ) Fasten the screws.
5 ) Connect the cable to the color sensor terminal on the rear upper bank but do NOT plug in to the power outlet.
Notes: Do not loosen the screws at the bottom of the panel. When attached to the rear panel, the sensor window
points upward.
If the color sensor attached to the rear panel does not operate properly, attach it to the front panel.
Do not use the supplied screws when attaching the color sensor using the speaker brackets.
The color sensor may become hot due to a heat emitted from the panel. When using it in a high-
temperature environment, attach the color sensor to the bottom of the front panel.
(Bracket for PRO-151FD)
The bracket is for PRO-151FD panel but the procedure is the same for PRO-111FD.
Color sensor cable
Cable clamp
Color sensor terminal
(upper bank)
Cable clamp
Color sensor
Speaker cable
PRO151FD.book Page 27 Wednesday, April 2, 2008 10:19 AM