Filter
Top Products
33
En
02
Install Your Flat Panel TV
Follow the steps below to attach a cable clamp.
1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp.
2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat panel TV.
3 ) Pull up the clamp band to lock.
4 ) Confirm that the cable clamp is seated firmly in the panel.
Note: Avoid pinching or creating pressure points when routing or bundling cables.
To remove the clamp band, pull and hold the latch to release.
To remove the cable clamp, push and hold the levers then pull it out from the hole.
Note: The longer a clamp is in place, the better chance of deterioration. An older clamp is more easily damaged
while being removed and may not be reusable.
1
2
Cable clamp
Latch
Lever
Lever
PRO151FD.book Page 33 Wednesday, April 2, 2008 10:19 AM