Filter
Top Products
81
9-4 Items in the Extended Setup Menu
Chapter 9 Setup Menus
107 REC INHIBIT LAMP
FLASHING
Select whether to flash the REC INHI indicator when RECINH in function menu is
set to “OFF” and the record inhibit plug on the cassette is pressed in.
OFF
: Do not flash.
ON: Flash.
108 AUTO EE SELECT Select the VTR modes in which input video and audio signals are automatically
handled in E-E mode when a cassette is inserted and PB/EE in function menu is
set to “EE”.
S/F/R
: In STOP/EJECT/F.FWD/REW modes
STOP: In STOP/EJECT modes
109 FORCED EE WHEN TAPE
UNTHREAD
Select whether or not the setting of PB/EE in function menu controls the PB/EE
setting for output signals during tape threading and unthreading, and when no
cassette is inserted.
OFF: Control.
ON: No control (always E-E signal).
111 TSO PLAY Select whether or not to enable tape speed override mode.
DIS: Disabled
TSO: Enabled
116 JOG DIAL RESPONSE Select the tape speed characteristics for the search dial rotation rate (VTR
commands).
TYPE1
: Tape speed varies linearly over the range –1 to +1.
TYPE2: Tape speed varies stepwise as shown in figure “TYPE 2”
a)
below over the
range –3 to +3. (Characterized by a zone around –1 and +1 where the tape
speed is independent of the search dial rotation rate. When playing back an
HDCAM tape, however, tape speed characteristic figure “TYPE 4”
c)
below
applies.)
TYPE3: Tape speed varies linearly over the range –3 to +3 (±2 during HDCAM tape
playback), as shown in figure “TYPE 3”
b)
below.
TYPE4: Tape speed varies stepwise as shown in figure “TYPE4”
c)
below over the
range –2 to +2. (Characterized by a zone around –1 and +1 where the tape
speed is independent of the search dial rotation rate)
118 KEY INHIBIT SWITCH
EFFECTIVE AREA
Select which switches and buttons can be operated when the KEY INHI switch on
the switch panel is set to “ON”. The following sub-items control different sets of
switches and buttons independently.
Sub-item
1 REMOTE SELECT Select whether or not the REMOTE 1(9P)/2(50P) buttons in the upper control
panel are enabled.
DIS
: Disabled
ENA: Enabled
2 F-KEY (FUNCTION
KEY)
Select whether to enable the selection buttons (F1 to F10 and P1 to P5, DISPLAY)
in the lower control panel of this unit.
DIS: Disabled
ENA: Enabled
3 CONTROL PANEL Select which switch and button operations can be carried out from the lower
control panel of this unit.
DIS: All switches and buttons are disabled.
ENA: All switches and buttons are enabled.
Menu items in the range 100 to 199, relating to the control panels (Continued)
Item number Item name Settings
+3
+1
-1
-3
FWD
FWD
RVS
RVS
+2
+1
-1
-2
FWD
FWD
RVS
RVS
b) c)
(forward)
Rotation rate Rotation rate
Speed SpeedTYPE 3
TYPE 4
a)
Speed
TYPE 2
(
reverse)
+3
-3
FWD
FWD
RVS
RVS
Rotation rate