Filter
Top Products
94
9-4 Items in the Extended Setup Menu
Chapter 9 Setup Menus
• For menu items 715 to 718 or 740 to 747, set F5
(V.PROC) in function menu item P03: VID PROC to
“MENU”. When it is set to “MENU”, all controls for
video output processing on the control panel are
disabled.
• When menu item 337 is set to “SD”, changing the
settings of menu items 719 and 720 changes the phase of
HD output signals as well as that of SD.
After changing these settings, use F3 (SYNC PHS) and
F4 (SYNC FIN) in function menu page P03: VID PROC,
or menu items 745 and 746 to readjust the phase of HD
output signals.
718 SETUP LEVEL (Has no effect in 24PsF or 23.98PsF mode)
Adjust the SD setup level (black level).
0 to 110H
to 220H
Note
This item is valid for both HD and SD outputs when sub-item “D2 SETUP” of menu
item 212 “VIDEO REMOTE CONTROL SELECT” is set to “Black”.
719 SYSTEM PHASE SYNC Adjust the SD output signal sync phase.
0 to 80H to FFH
720 SYSTEM PHASE SC Adjust the SD output signal subcarrier phase.
0 to 3FFH
Menu items in the range 700 to 799, relating to video control (continued)
(Menu items in the range 715 to 720, settings for controlling the SD video processing according to the menu settings)
Item number Item name Settings
Notes
Menu items in the range 700 to 799, relating to video control (continued)
Item number Item name Settings
726 H BLANKING WIDTH Select the horizontal blanking width of the video output signal.
NAROW: Digital blanking (narrow)
WIDE: Analog blanking (wide)
When “WIDE” is selected, the horizontal blanking width complies with RS170A,
and normally the blanking is widened and the image becomes narrower. It is
recommended to select “NAROW” at editing, then select “WIDE” for broadcast
transmission to output a signal conforming to the standard.
727 VIDEO EDIT PREVIEW
SWITCHER
Set the output phase for the video playback signal when any of F2 (INS TC), F3
(INS CUE), and F5 (ASSEMBLE) to F10 (INS A4) in function menu page P07:
E.PRESET is lit.
INT
: The video playback signal output phase is the same as the output phase in E-
E mode. Use this setting when editing with a single VTR, or when previewing
while monitoring the VTR output signal.
EXT: The video playback signal output phase is the same as the phase of an input
video signal or external reference signal.
728 OUTPUT SCH PHASE Control the subcarrier H phase.
0 to 800H
to FFFH
732 COMPOSITE MODE Select the chroma filter through which the composite video signals are output.
WIDE: Output via SMPTE WIDE.
STD: Output via SMPTE STANDARD (NARROW).
740 MASTER LEVEL (HD) Adjust the Y, P
B
, and P
R
levels of the high-definition video signal output from the
HDSDI OUTPUT connector simultaneously.
0.0%(0H) to 100% (800H)
to 141.3% (B4EH)
741 Y LEVEL (HD) Adjust the Y level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0.0% (0H) to 100% (800H)
to 141.3% (B4EH)
742 P
B LEVEL (HD) Adjust the P
B
level of the high-definition video signal output from the HDSDI
OUTPUT connector.
0.0% (0H) to 100% (800H)
to 141.3% (B4EH)