C:\3210862411RDRHX750CA2\01GB-
RDRHX750CA2\130ADJ.fm
master page=right
specdef20070130
RDR-HX750
3-210-862-41(1)
105
Settings and Adjustments
DTS Output (DVD VIDEOs only)
Selects whether or not to output DTS signals.
b Note
When HDMI output is performed to equipment not
compatible with DTS signals, the signals will not be
output regardless of the “DTS Output” setting.
96 kHz PCM Output (DVD VIDEOs only)
Selects the sampling frequency of the audio
signal.
b Notes
• “96 kHz PCM Output” setting has no effect when
audio signals are output from the LINE OUT (R-
AUDIO-L) jacks. If the sampling frequency is
96 kHz, signals are simply converted to analog
signals and output.
• If the HDMI OUT jack is connected to equipment
not compatible with 96 kHz signals, 48 kHz PCM
will be automatically output even when you select
“96 kHz.”
MPEG Output (DVD VIDEOs only)
Selects the type of MPEG audio signal.
b Note
If the HDMI OUT jack is connected to equipment
not compatible with MPEG audio signals, the PCM
signals will be automatically output even when you
select “MPEG.”
Audio DRC (Dynamic Range Control)
(DVDs only)
Selects the dynamic range (difference
between soft and loud sounds) setting when
playing a DVD that conforms to “Audio
DRC.” This affects the output from the
following jacks:
–LINE OUT R-AUDIO-L jacks
–DIGITAL OUT (COAXIAL)/HDMI OUT
jack only when “Dolby Digital Output” is
set to “Dolby Digital -> PCM” (page 104).
On Select this when the
recorder is connected to an
audio component with a
built-in DTS decoder.
Off Select this when the
recorder is connected to an
audio component without a
built-in DTS decoder.
96 kHz ->
48 kHz
The audio signals of DVD
VIDEOs are converted to
48 kHz and output.
96 kHz All signals containing
96 kHz are output without
conversion. However, the
signals are output at 48 kHz
if copyright-protected
signals are contained.
MPEG Select this when the
recorder is connected to an
audio component with a
built-in MPEG decoder.
MPEG ->
PCM
Select this when the
recorder is connected to an
audio component without a
built-in MPEG decoder. If
you play MPEG audio
sound tracks, the recorder
outputs stereo signals via
the DIGITAL OUT
(COAXIAL) jack.
On Makes low sounds clear
even if you turn the volume
down.
Off
Normally select this
position.