Filter
Top Products
C:\3210862411RDRHX750CA2\01GB-
RDRHX750CA2\040BAS.fm
master page=right
specdef20070130
RDR-HX750
3-210-862-41(1)
21
Hookups and Settings
B Audio L/R (left/right) input jacks
This connection will use your TV’s or audio
components two speakers for sound.
z Hint
For correct speaker location, see the operating
instructions supplied with the connected
components.
b Notes
• Do not connect your TV’s audio output jacks to
the LINE IN (R-AUDIO-L) jacks at the same
time. This will cause unwanted noise to come
from your TV’s speakers.
• With connection B, do not connect the LINE IN
(R-AUDIO-L) and LINE OUT (R-AUDIO-L)
jacks to your TV’s audio output jacks at the same
time. This will cause unwanted noise to come
from your TV’s speakers.
• With connection A, after you have completed the
connection, make the appropriate settings in the
“Audio Out” setup (page 104). Otherwise, no
sound or a loud noise will come from your
speakers.
• When you connect the recorder to an audio
component using an HDMI cord, you will need to
do one of the following:
– Connect the audio component to the TV with
the HDMI cord, or
– Connect the recorder to the TV with a video
cord other than HDMI cord (component video
cord, S-video cord, or audio/video cord).
*1
Manufactured under license from Dolby
Laboratories.
“Dolby” and the double-D symbol are
trademarks of Dolby Laboratories.
*2
“DTS” and “DTS Digital Out” are registered
trademarks of DTS, Inc.
Step 4: Connecting the
AC Power Cord
Connect the supplied AC power cord to the
AC IN terminal of the recorder. Then plug the
recorder and TV power cords into the AC
outlet. After you connect the AC power cord,
you must wait for a short while before
operating the recorder. You can operate
the recorder once the front panel display
lights up and the recorder enters standby
mode.
If you connect additional equipment to this
recorder (page 26), be sure to connect the AC
power cord after all connections are
complete.
to AC outlet
to AC IN
1
2