Filter
Top Products
Creating and Downloading a Logo
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page E-9
ST.TM.E10076.3
E.6 Downloading a Logo Using OSD Loader
The Osd Loader application (osd.exe) is used for downloading logo (.osd)
files to the Encoder and controlling which are displayed.
The application runs on a PC with Windows 95 or Windows NT. A network
connection is required. The target Encoder's IP address must be visible
from the host PC.
The application uses the .osd file format for images. These can be derived
from Windows .bmp files using the OSD Creator application (see Section
E.4, Creating a Logo Using OSD Creator).
An example of an OSD Loader screen is shown in Figure E.5.
Figure E.5: OSD Loader Screen Showing Example Logo
E.7 Using the OSD Loader
E.7.1 Start-up
Activate the application (osd.exe). The application attempts to connect to
the last known Encoder address. If the address is not correct, click the
Abort button and enter the IP address of the target Encoder. This can be
found on the Encoder front panel by selecting Setup/System/Remote
Control. To test the connection, click the Remove All button (you will be
prompted for confirmation – Remove all OSD Regions Yes/No). The
communications box (at the top of the screen) should read Transfer
Completed OK.