Filter
Top Products
Installing the Equipment
Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder Page 2-3
ST.TM.E10076.3
2.1 Introduction
2.1.1 Read This First!
The Encoder must be handled carefully and thoughtfully to prevent safety
hazards and damage. It is usually supplied as part of a system installed by
TANDBERG Television engineers. In any case, ensure the personnel
designated to install the unit have the appropriate skills and knowledge. If
in any doubt, contact Customer Services.
Follow the instructions for installation and only use installation accessories
recommended by the manufacturers.
2.1.2 General
Installation of the Encoder is normally performed by TANDBERG Television
personnel. This chapter provides configuration and connection information
for planning installations, checking the final set-up in the event of a fault,
modifying the requirements or moving the equipment to another location.
In the event of problems, contact Customer Services.
2.1.3 Site Requirements
Power Supplies
See Annex B, Technical Specification for a full specification.
Environment
See Annex B, Technical Specification for a full specification.
Do not install this product in areas of high humidity or where there is
danger of water ingress.
Lightning Protection
WARNING…
IF THE ENCODER HAS BEEN SUBJECT TO A LIGHTNING STRIKE OR POWER SURGE WHICH
HAS STOPPED IT WORKING, DISCONNECT THE POWER IMMEDIATELY. DO NOT REAPPLY
POWER UNTIL IT HAS BEEN CHECKED FOR SAFETY. IF IN DOUBT, CONTACT TANDBERG
TELEVISION CUSTOMER SERVICES.
Where appropriate, ensure this product has an adequate level of lightning
protection. Alternatively, during a lightning storm or when it is left
unattended and unused for long periods of time, unplug it from the supply
outlet and disconnect the output equipment. This prevents damage to the
product due to lightning and power line surges.
2.1.4 EMC Compliance Statements
1
EN 55022 / AS/NZS 3548
This equipment is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
1
The EMC information was correct at the time of manufacture. The EMC tests were performed with the Technical
earth attached.