Filter
Top Products
Error Messages
Page H-6 Instruction Manual: evolution 5000 E57xx DSNG and DENG Voyager Encoder
ST.TM.E10076.3
H.5 VBI Related Errors
Table H.3: VBI Error Messages
Error Message Action to Take
Duplicate VBI PID
Invalid VBI PID
Duplicate Teletext PID
Invalid Teletext PID
Check the Encoder configuration.
Closed Caption (Line 21)
Closed Caption (Ext. Data)
Neilson/AMOL 1 Detection
Neilson /AMOL 11 Detection
VPS Detection
WSS Detection
VITC Detection
Video Index Detection
No Teletext Data Detected
No inverted Teletext Dat
Verify that the appropriate VBI is present in the video source. If it is, power
Encoder off, then check that the Base Board is firmly seated in the chassis. Do
this by firmly pressing it from the rear of the Encoder into the chassis. Power on
the Encoder. If the fault persists call Service Engineer.
H.6 Remote Control Related Errors
Table H.4: Remote Control Error Messages
Error Message Action to Take
Ethernet Comms
SNMP Undo Fail
Power Encoder off, then check that the Base Board is firmly seated in the
chassis. Do this by firmly pressing it from the rear of the Encoder into the chassis.
Power on the Encoder. If the fault persists call Service Engineer.
H.7 Data Related Errors
Table H.5: Data Error Messages
Error Message Action to Take
Comms Error
Config Update
Processor Stopped
Power Encoder off, then check that the Base Board and any data modules are
firmly seated in the chassis. Do this by firmly pressing them from the rear of the
Encoder into the chassis. Power on the Encoder. If the fault persists call Service
Engineer.
Duplicate PID
Invalid PID
Mux Bit-Rate too low
Data Overflow
Data Underflow
Mux FIFO Full
Check the Encoder configuration.