Table 9-11 1660-Series Oscilloscope Module Event Status Register
Bit Bit Weight Bit Name Condition
7 128 0 = not used
6 64 0 = not used
5 32 0 = not used
4 16 1 = Number of averages satisfied
0= Number of averages not satisfied
3 8 1 = Auto trigger received
0= Auto trigger not received
2 4 1= Trigger received
0= Trigger not received
1 2 RNT 1 = Run until satisfied
0 = Run until not satisfied
0 1 MC 1 = Measurement complete
0 = Measurement not complete
RMODe
Command :RMODe {SINGle|REPetitive}
The RMODe command specifies the run mode for the selected module (or
Intermodule). If the selected module is in the intermodule configuration,
then the intermodule run mode will be set by this command.
After specifying the run mode, use the STARt command to start the acquisition.
Example OUTPUT XXX;":RMODE SINGLE"
Mainframe Commands
RMODe
9–18