Filter
Top Products
LOAD :IASSembler
Command :MMEMory:LOAD:IASSembler <IA_name>[,<msus>],{1|2}
[,<module>]
This variation of the LOAD command allows inverse assembler files to be
loaded into a module that performs state analysis. The <IA_name>
parameter specifies the inverse assembler filename from the desired
<msus>. The parameter after the optional <msus> specifies which machine
to load the inverse assembler into.
The optional <module> parameter is used to specify which slot the state
analyzer in. 1 refers to the logic analyzer. If this parameter is not specified,
the state analyzer will be selected.
<IA_name> A string of up to 10 alphanumeric characters for LIF in the following form:
NNNNNNNNNN
or
A string of up to 12 alphanumeric characters for DOS in the following form:
NNNNNNNN.NNN
<msus> Mass Storage Unit Specifier (not needed by 1660-series. 16500A <msus> is
accepted but no action is taken).
<module> An integer, always 1
Examples OUTPUT XXX;":MMEMORY:LOAD:IASSEMBLER ’I68020 IP’,1"
OUTPUT XXX;":MMEM:LOAD:IASS ’I68020 IP’,INTERNAL0,1,2"
MMEMory Subsystem
LOAD :IASSembler
11–15