Filter
Top Products
Transferring the logic analyzer configuration
This program uses the SYSTem:SETup query to transfer the configuration
of the logic analyzer to your controller. This program also uses the
SYSTem:SETup command to transfer a logic analyzer configuration from the
controller back to the logic analyzer. The configuration data will set up the
logic analyzer according to the data. It is useful for getting configurations for
setting up the logic analyzer by the controller. This query differs from the
SYSTem:DATA query because it only transfers the configuration and not the
acquired data. The SYSTem:SETup command differs from the
SYSTem:DATA command because it only transfers the configuration and not
acquired data.
10 ! ****************** SETUP COMMAND AND QUERY EXAMPLE ********************
20 ! for the 1660-series logic analyzers
30 !
*** ! ********************* CREATE TRANSFER BUFFER *************************
50 ! Create a buffer large enough for the block data. See page 26-9 for
55 ! maximum block length.
56 !
60 ASSIGN @Buff TO BUFFER [170000]
70 !
80 ! **************** INITIALIZE GPIB DEFAULT ADDRESS *********************
90 !
100 REAL Address
110 Address=707
120 ASSIGN @Comm TO Address
130 !
140 CLEAR SCREEN
150 !
160 ! ************* INTITIALIZE VARIABLE FOR NUMBER OF BYTES *****************
170 ! The variable "Numbytes" contains the number of bytes in the buffer.
180 !
190 REAL Numbytes
200 Numbytes=0
210 !
220 ! ************** RE-INITIALIZE TRANSFER BUFFER POINTERS ******************
230 !
240 CONTROL @Buff,3;1
250 CONTROL @Buff,4;0
260 !
270 ! *********************** SEND THE SETUP QUERY **************************
Programming Examples
Transferring the logic analyzer configuration
36–14