Introduction
This chapter contains short, usable, and tested program examples
that cover the most asked for examples. The examples are written in
HP Basic 6.0.
• Making a timing analyzer measurement
• Making a state analyzer measurement
• Making a state compare measurement
• Transferring logic analyzer configuration between the logic analyzer
and the controller
• Transferring logic analyzer data between the logic analyzer and the
controller
• Checking for measurement completion
• Sending queries to the logic analyzer
• Getting ASCII data with PRINt? All query
• Reading a disk catalog
• Printing to the disk using PRINT? ALL
• Transferring waveform data in Byte format
• Transferring waveform data in Word format
• Using AUToscale and the MEASure:ALL? Query
• Using subroutines in a measurement program
36–2