Filter
Top Products
INSert
Command :MACHine{1|2}:SWAVeform:INSert
<label_name>,<bit_id>
The INSert command allows you to add waveforms to the state waveform
display. Waveforms are added from top to bottom on the screen. When 96
waveforms are present, inserting additional waveforms replaces the last
waveform. Bit numbers are zero based, so a label with 8 bits is referenced as
bits 0 through 7. Specifying OVERlay causes a composite waveform display
of all bits or channels for the specified label.
<label_name> string of up to 6 alphanumeric characters
<bit_id> {OVERlay|<bit_num>ALL}
<bit_num> integer representing a label bit from 0 to 31
Examples OUTPUT XXX;":MACHINE1:SWAVEFORM:INSERT ’WAVE’, 19"
OUTPUT XXX;":MACHINE1:SWAVEFORM:INSERT ’ABC’, OVERLAY"
OUTPUT XXX;":MACH1:SWAV:INSERT ’POD1’, #B1001"
RANGe
Command :MACHine{1|2}:SWAVeform:RANGe <number_of_samples>
The RANGe command allows you to specify the number of samples across
the screen on the State Waveform display. It is equivalent to ten times the
states per division setting (states/Div) on the front panel. A number between
10 and 5000 may be entered.
<number_of_
samples>
integer from 10 to 5000
Example OUTPUT XXX;":MACHINE2:SWAVEFORM:RANGE 80"
SWAVeform Subsystem
INSert
18–8