Filter
Top Products
LOAD [:CONFig]
Command :MMEMory:LOAD[:CONfig] <name>[,<msus>][,<module>]
The LOAD command loads a configuration file from the disk into the logic
analyzer, oscilloscope, software options, or the system. The <name>
parameter specifies the filename from the disk. The optional <module>
parameter specifies which module(s) to load the file into. The accepted
values are 0 for system, 1 for logic analyzer, and 2 for the oscilloscope. Not
specifying the <module> parameter is equivalent to performing a ’LOAD
ALL’ from the front panel which loads the appropriate file for the system,
logic analyzer, oscilloscope, and any software option.
<name> A string of up to 10 alphanumeric characters for LIF in the following form:
NNNNNNNNNN
or
A string of up to 12 alphanumeric characters for DOS in the following form:
NNNNNNNN.NNN
<msus> Mass Storage Unit Specifier (not needed by 1660-series. 16500A <msus> is
accepted but no action is taken).
<module> An integer, 0 through 2
Examples OUTPUT XXX;":MMEMORY:LOAD:CONFIG ’FILE ’"
OUTPUT XXX;":MMEMORY:LOAD ’FILE ’,0"
OUTPUT XXX;":MMEM:LOAD:CONFIG ’FILE A’,INTERNAL0,1"
MMEMory Subsystem
LOAD [:CONFig]
11–14