Filter
Top Products
CLRPattern
Command :MACHine{1|2}:TWAVeform:CLRPattern {X|O|ALL}
The CLRPattern command allows you to clear the patterns in the selected
Specify Patterns menu.
Example OUTPUT XXX;":MACHINE1:TWAVEFORM:CLRPATTERN ALL"
CLRStat
Command :MACHine{1|2}:Twaveform:CLRStat
The CLRStat command allows you to clear the waveform statistics without
having to stop and restart the acquisition.
Example OUTPUT XXX;":MACHINE1:TWAVEFORM:CLRSTAT"
DELay
Command :MACHine{1|2}:TWAVeform:DELay <delay_value>
The DELay command specifies the amount of time between the timing
trigger and the horizontal center of the the timing waveform display. The
allowable values for delay are −2500 s to +2500 s. If the acquisition mode is
automatic, then in glitch acquisition mode, as delay becomes large in an
absolute sense, the sample rate is adjusted so that data will be acquired in
the time window of interest. In transitional acquisition mode, data may not
fall in the time window since the sample period is fixed and the amount of
time covered in memory is dependent on how frequent the input signal
transitions occur.
TWAVeform Subsystem
CLRPattern
23–9