PATH
Command :TRIGger:[MODE PATTern;]PATH {CHANnel<N>}
The PATH command is used to select a trigger path for the subsequent
LOGic and LEVel commands. This command can only be used in the
PATTern trigger mode.
<N> An integer from 1 or 2
Example OUTPUT XXX;":TRIGGER:PATH CHANNEL1"
Query :TRIGger:PATH?
The PATH query returns the current trigger path.
Returned Format
[:TRIGger PATH] {CHANnel<N>}<NL>
Example OUTPUT XXX;":TRIGGER:PATH?"
SLOPe
Command :TRIGger:[MODE EDGE;SOURce {CHANnel<N>};]SLOPe
{POSitive|NEGative}
The SLOPe command selects the trigger slope for the specified trigger
source. This command can only be used in the EDGE trigger mode.
<N> 1 or 2
Example OUTPUT XXX;":TRIG:SOUR CHAN1;SLOP POS"
TRIGger Subsystem
PATH
34-12