Filter
Top Products
FIND
Command :MACHine{1|2}:TTRigger:FIND<N>
<time_qualifier>,<condition_mode>
The FIND command defines the time qualifier for a given sequence level.
The qualifier tells the timing analyzer when to proceed to the next sequence
level. When this proceed qualifier is matched the specified number of times,
the sequencer will proceed to the next sequence level. In the sequence level
where the trigger is specified, the FIND command specifies the trigger
qualifier (see SEQuence command).
The terms A through J are defined by the TERM command. The meaning of
IN_RANGE and OUT_RANGE is determined by the RANGe command.
Expressions are limited to what you could manually enter through the Timing
Trigger menu. Regarding parentheses, the syntax definitions below show
only the required ones. Additional parentheses are allowed as long as the
meaning of the expression is not changed. See figure 12-2 on page 12-11 for
a detailed example.
<N> integer from 1 to the number of existing sequence levels (maximum 10)
<condition_
mode>
{{GT|LT}, <duration_time>|OCCurrence, <occurrence>}
GT greater than
LT less than
<duration_time> real number from 8 ns to 5.00 seconds depending on sample period
<occurrence> integer from 1 to 1048575
<time_
qualifier>
<qualifier> see "Qualifier" on page 22-6
Examples
OUTPUT XXX;":MACHINE1:TTRIGGER:FIND1 ’ANYSTATE’, GT, 10E−6"
OUTPUT XXX;":MACHINE1:TTRIGGER:FIND3 ’((NOTA AND NOTB) OR
G)’, OCCURRENCE, 10"
TTRigger (TTRace) Subsystem
FIND
22–13