Filter
Top Products
Removing and Replacing Parts 4-7
3. Remove the drive-mounting rails from the drive (see Figure 4-7).
Figure 4-7. Drive-Mounting Rails Removal
4. If the drive is a SCSI drive, record the setting of the SCSI address
jumpers and SCSI bus termination jumpers.
Some drives use an adapter between the SCSI cable and the drive connector.
Check the back of the old drive for an adapter. If an adapter is present,
remove it and retain it for use on the new drive.
NOTE: When reinstalling the SCSI drive, set the SCSI address jumpers and the
SCSI bus termination jumpers to the settings you recorded.
drive-release tabs (2)
drive-mounting
rails (2)